Tcp/Ip - Atlona AT-UHD-SW-52ED User Manual

TCP/IP Settings of Controlled Device
This option sets the IP for display control. The static IP set here should match the display's static IP.
To set or view the display's IP address, check the display's user manual.
Note: The switcher and the display must be on the same network for these commands to work
Note: Be sure the static IP address set for the display does not match any other device on the network
IP Mode
Non-login: Does not require a username and password when using TCP/IP to control the
display
Login: Requires a username and password to control the display through TCP/IP
IP Address & Port - Set to match the display's static IP
Username & Password - Required when in login mode
Save - Saves the IP settings for accessing the controlled device
RS-232/IP Commands
ASCII/Hex - Set which type of commands are sent to the display
On/Off/Volume+/Volume-/Mute - Enter the specific commands and feedback that will be sent/
received when using any of the control options
Note: Individual commands will be found in the display's manual
End of line symbols - None, CR, LF, CR-LF, Space, STX, ETX, Null - Select the appropriate symbol
from the drop down list. Carriage return, line feed, and carriage return with line feed
are the most commonly used symbols.
Note: Be sure to check the display's manual for the correct symbol
atlona.com
15
Toll free: 1-877-536-3976
Local: 1-408-962-0515