Atlona AT-UHD-SW-52ED User Manual page 8

Ethernet
For convenience, the UHD-SW-52ED comes with DHCP on. This enables the switcher to be
connected to a network without knowing available IP addresses. If your network does not allow
dynamic IP addresses or if you are using the switcher with a TCP/IP control system, this feature may
be turned off and the IP address set using RS-232 commands or the webGUI.
WebGUI
Atlona has created an easy to use webGUI for initial setup and later changes to the configuration
of the switcher.
To begin, plug a LAN cable into the LAN port of the UHD-SW-52ED and the network switch, then
type the IP address of the unit into a web browser of a PC connected to the same network
.
below)
To find the switcher IP: use RS-232 command "IPCFG".
Note: IP addresses may also be found using common free IP scanner software such as "Advanced IP
Scanner"
Important: If any stability issues are experienced, disable any anti-virus or firewall that may interfere with
network communication to the switcher. Once set up is done and the switcher webGUI is no
longer used, the firewall and anti-virus can be re-enabled.
A login screen will appear
the username is "root" and password is "Atlona".
admin changes)
Note: Only the admin password can be changed (see page 9). The username will always remain "root".
atlona.com
(this is the same log in for admin and general users)
8
(as seen
. For the first log in
(and future
Toll free: 1-877-536-3976
Local: 1-408-962-0515