Farymann Diesel 15W Repair Manual page 55

REASSEMBLY PROCEDURES
19. Injection pump
Place acceleration lever in full load (max speed)
position and pull excess fuel button. Place rod of
the fuel injection pump to max position. When
sliding in the pump, the pin of the rod must grip
into the yoke of the control lever. Reinstall the
injection pump by using the same number and
types of shims as were on the engine before.
(See chapter -> injection timing !)
First install the paper gasket in any case.
Attention
To check correct assembly of the fuel injection
pump turn the acceleration lever to stop-
position. Excess fuel button must push back to
normal operating position !
20 High pressure fuel line
Install the high pressure fuel line and tighten the
union nuts on injector and pump. While tighten-
ing nut on injector and pump maintain counter
parts with a 14 mm wrench.
21 Valve cover
Install the valve cover gasket and the valve
cover taking care the gasket is properly seated
on the cylinder head. Insert new plastic washers
and tighten to specified torque.
- 55 -