Table of Contents
Advertisement
8. Decompression release
Remove 2 screws and pull the decompression
Release out of the gearhousing.
Check gasket and o-seal. Replace if necessary.
Caution
Take care not to loose the guide pin !
With missing guide pin shaft will move out when
engine is in operation !
9. Cylinder
Rotate the flywheel until the piston the bottom of
ist stroke. Carefully slide the cylinder up of the
studs.
Check o-seals of water-overflow-jackets. Re-
place if necessary.
Caution
If the repair doesn't require replacement of pis-
ton and liner, leave the liner on the piston.
Pull up liner so far that piston pin bore is free ->
See next step.
RE-ASSEMBLING PROCEDURES
- 25 -
Hide quick links:
Advertisement
Table of Contents
