Farymann Diesel 15W Repair Manual page 45

REASSEMBLY PROCEDURES
5. Oilpump
Reassemble oilpump with thin pressure relief
plate, spring retaining clip and gasket. Before
tightening the screws to specified torque pull the
pump downwards. The clearance in the screw
holes allows a sufficient backslash between
crankshaft gear and pump gear.
6. Governor
Install holding device ( special tools ) on crank-
shaft or fix crankshaft with a hammer stick.
Make sure that governor and crankshaft threads
are free of oil and grease. Apply a couple of
trops of Loctite 270 ( or similar ) on the governor
thread. Torque the governor down according the
torque table.
Attention
Governor with lefthand thread ! Spread fly-
wheights to mount the socket of the torque
wrench.
For correct governor setting refer to section Ad-
justments !
7. Connecting rod
To install new bearing shells, take a shell half
and lay it to approx. ¾ into the cap. Now press
the bearing in a slidung move onto its seat. The
bearing lip must fit into the groove in the cap.
Install the bearing shell on the rod-side in the
same way.
- 45 -