Farymann Diesel 15W Repair Manual page 28

To remove the injection pump camfollower un-
screw fixing screw ( arrow )through oil filling
bore.
15. Camshaft
Remove the circlip lock ring fixing the camshaft
in the gear end cover. Press out the camshaft
using a driver ( see special tool list ).
To pull off the camshaft gear wheel use puller or
press.
After removing the camshaft the roller bearing
can be pressed out from the inside of the cover
using a special driver.
RE-ASSEMBLING PROCEDURES
- 28 -
Remove the 2 hex nuts and lock washers. Pull
off the inj. Pump. If necessary turn the flywheel
to decrease force from the camshaft-side.
Caution
Leave gasket and shimson the gear end hous-
ing. Re-install hex nuts and lock washers on
their studs.