Farymann Diesel 15W Repair Manual page 52

REASSEMBLY PROCEDURES
Move the timing mark on the camshaft gearex-
actly 3 teeth to the left.
Install the gear end cover. Align the flywheel
mark and the crankcase timing mark.
Check timing marks on camshaft gear and gear
end cover. The timing is acceptable if these are
within 0 – 2 mm to the left side !
Note :
If the camshaft mark is in right side position the
valves will come in contact with the piston ( hot
engine ).
Place new o-ring in the flute of the crankhandle
support. Lubricate the camshaft and the sealing
lips of the oil sealing ring. Don't push the guide
straight onto the gear end cover. Instead use a
light twisting motion until the guide seats itself.
Tighten the screws to specified torque.
13. Decompression device
Slide the pushrod tube up into the ist hole in the
cylinder head as far as possible. Remember to
install a new o-ring in the cylinder head. To
grease will help to assemble the tube.
Assemble the decompression device with new
o-ring and gasket.
Attention
Before reinstalling the decompression device
check if the retaining pin for the shaft is still in
place ( see arrow ).
- 52 -