Farymann Diesel 15W Repair Manual page 51

REASSEMBLY PROCEDURES
12. Gear end cover
To install the gear end cover, first bring the pis-
ton to TDC ( Top dead center ) position by
aligning the flywheel timing mark with the TDC
mark stamped on the crankcase.
Insert the governor pin into the bore in the gov-
ernor. Use grease to keep the pin in place.
Line up the timing mark on the camshaft gear
with the mark on the gear end cover.
Install the gear end cover onto the crankcase
being careful not to move the camshaft gear.
Remember to place the gasket !
After the cover is installed check the timing
marks on the flywheel side. If both marks are
within +/- 2mm lining up the timing is correct.
Insert the governor pin into the bore in the gov-
ernor. Use grease to keep the pin in place.
Occasionally, however, the governor will tighten
onto the crankshaft in position that makes it dif-
ficult to install the gear end cover. If this hap-
pens use the following procedure to install the
cover :
Turn the flywheel until ist timing mark aligns with
approx. 1 o'clock position.
- 51 -