Farymann Diesel 15W Repair Manual page 46

REASSEMBLY PROCEDURES
- 46 -
Notice the stamped numbers on conrod and cap
– side . These are matcjing marks i.e. identical
numbers must be on rod and cap.
Oil the bearing shells and install conrod into the
crankcase until it seats on the crank pin. Insert
conrod cap through the bottom inspection cover
Attention
The stamped numbers must be aligned on the
same side of the rod but it is not important which
engine side the numbers face. Thighten the con-
rod nuts to the specified torque and reinstall
crankcase cover.
.
8. Camshaft
Heat the camshaft gear wheel in an oil bath or
an electric heater plate to 90-100 °C ( 195-210
°F). Thrust gear onto the camshaft using a suit-
able lenght of pipe and a hydraulic press.
Attention
The timing mark must face towards cam side of
assembly.
Press the camshaft bearing into the gear
end cover using a driver.