Table of Contents
Advertisement
16. Speed control assembly
Remove the retaining ring from the eccenter
shaft using a pliers. Pull the exc. shaft outwards
till the ratchet plate is free from the compression
pin. Unhook the outer torsion spring from the
boss ( use a pliers and watch out for your fin-
gers). Hold the inner control lever and twist ac-
celeration lever down to stop-position till the
inner torsion spring is without tension. Then pull
eccenter shaft out of control lever and bearing
bush.
RE-ASSEMBLING PROCEDURES
- 29 -
17. Governor
Install holding device ( special tools )
Remove governor pin from governor.
Spread flywheights with a screwdriver and use
14 mm socket to unscrew governor.
Caution
Governor mounted with left-hand-thread !
Hide quick links:
Advertisement
Table of Contents
