Table of Contents
Advertisement
20. Main bearing housing
Remove the 4 main bearing housing nuts and
washers.
Next install 2 screws M6 x 30 into the thread
holes. Screw them in until the housing breaks
loose.
RE-ASSEMBLING PROCEDURES
- 30 -
18. Oil pump
Remove the oil pump and valve bracket by un-
screwing the 3 mounting screws.
Discard gasket.
19. Flywheel
Remove the oil pump and valve bracket by un-
screwing the 3 mounting screws.
Discard gasket.
Leave the flywheel nut on the shaft. Install fly-
wheel puller and turn the screws until the fly-
wheel breaks loose from the crankshaft tapper.
Remove the puller, flywheel nut and flywheel.
Hide quick links:
Advertisement
Table of Contents
