Table of Contents
Advertisement
7
BELL: INITIAL SCAN AND RECEIVER CONFIGURATION
IF YOU CHOSE DISH MODE, SKIP THIS SECTION AND GO TO SECTION 10.
Place the antenna unit in a position with a clear view of
the southern sky to scan for the satellites.
Place the KING Quest on a stable and reasonably level surface with a clear view of the southern sky.
When placing the KING Quest in position, be sure surface is dry and free of loose dirt or sand.
1. Turn on the TV and satellite receiver.
2. Press POWER to turn on KING Quest controller. Wait for the COAX CONNECTION light to stop
flashing and remain on.
3. Press SCAN. The antenna will scan and locate all of the appropriate satellites before completing
the search process.
PLEASE BE PATIENT! This initial scan may take up to 15 minutes to complete. After this initial scan,
subsequent scans may take as little as 2 minutes, but may occasionally take up to 10-15 minutes.
After the satellite acquisition process is complete, specific SCAN PROGRESS lights will turn on
to show which satellites have been found.
4. GO TO NEXT PAGE TO CONFIGURE RECEIVER.
IMPORTANT!
Any tall objects can block
the signal from reaching
the antenna.
Page 7
Advertisement
Table of Contents
