Table of Contents
Advertisement
The KING Quest is factory preset for BELL HD AND SD (satellites 82 and 91).
If this is your desired service option, you do not need to configure your antenna. Go to section 7.
If you wish to use the Bell SD service option (satellite 91), or the DISH mode, you will need to reconfigure the antenna
as shown below.
1. Press POWER to turn on the controller. Wait for the lights to stop flashing and for the COAX
CONNECTION light to remain on.
2. Press and hold SCAN for five seconds. The COAX CONNECTION light and the SCAN
PROGRESS lights that indicate the currently selected service will begin flashing.
3. Press SCAN repeatedly to scroll thru the available service options.
4. When the correct lights turn on to show your desired satellite configuration, press and hold SCAN
for five seconds to save in memory.
All SCAN PROGRESS lights will turn off and the COAX CONNECTION light will stop flashing
and remain on.
5. Press and hold POWER to turn off the controller. Bell go to section 7, DISH go to section 10.
To check which service is selected without changing it, perform steps 1, 2, 4 and 5.
Page 6
6
ANTENNA CONFIGURATION
DO NOT CHOOSE ANY GRAYED OUT SERVICE OPTION.
Advertisement
Table of Contents
