Table of Contents
Advertisement
IF YOUR RECEIVER IS NEW AND UNACTIVATED, START HERE.
WHILE IN USE, DO NOT BLOCK THE ANTENNA
UNIT'S LINE OF SIGHT TO THE SATELLITES IN
THE SOUTHERN SKY AT ANY TIME!
MAKE SURE TO INSTALL THE BATTERIES IN THE RECEIVER'S REMOTE
CONTROL (INCLUDED WITH REMOTE CONTROL).
Your TV screen may look different from what is shown in this manual.
Screen information may vary depending on choices you make during the setup process.
1. Point your receiver's remote at the front of
the receiver and press SAT.
Press RECORD.
When a number appears in the box,
verify "Continue" is highlighted.
Press SELECT on your remote.
Page 8
OPERATION
NEW AND UNACTIVATED WALLY RECEIVER
Otherwise go to STANDARD OPERATION on page 12.
For best results, follow the on-screen instructions.
IMPORTANT!
IMPORTANT!
If you move the antenna unit any
time during or after the scan, you
will have to repeat the scan.
Advertisement
Table of Contents
