Figure 18. Wallmount Installation - ADTRAN NetVanta 7000 Series Hardware Installation Manual

NetVanta 7000 Series Hardware Installation Guide
Wall Mounting the NetVanta
By following these instructions exactly, the NetVanta can be safely mounted to the wall.
Step
1 Attach the rackmount ears with the screws and brackets supplied in the Rackmount Kit.
2 Remove the mounting ears. Rotate them 90 degrees so that the portion of the bracket with the
mounting holes is flush with the bottom of the chassis. Reattach the mounting ears to the
chassis (see Figure 18 on page 45).
3 Decide on a location for the NetVanta 7100. Keep in mind that the unit needs to be mounted at
or below eye-level so that the LEDs are viewable.
4 Prepare the mounting surface by attaching a board (typically plywood, 3/ 4-inch to 1-inch thick)
to a wall stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
5 Have an assistant hold the unit in position as you install two #6 to #10 (1 1/ 2 inches or greater
in length) wood screws through the unit's brackets and into the mounted board (see Figure 18).
6 Proceed to the steps given in Supplying Power to the Unit on page 46.
To avoid damaging the unit, use only the screws included in the shipment when attaching
mounting ears to the chassis.
61200796L1-34D
Instructions for Wall Mounting the NetVanta

Figure 18. Wallmount Installation

Copyright © 2006 ADTRAN, Inc.
Action
Unit Installation
45