Transmit-Midi Transmit Channel Settings - Yamaha PSR-A5000 Reference Manual

Transmit—MIDI Transmit Channel Settings
The explanations here apply when you call up the "Transmit" display in step 2 on
MIDI channel is used for each part when MIDI data is transmitted from this instrument.
1
For each Part, select the MIDI Transmit Channel over which the
MIDI data of the corresponding Part is to be transmitted.
With the exception of the two parts below, the configuration of the parts is the
same as those already explained elsewhere in the Owner's Manual.
• Upper: A keyboard part played on the right side of the keyboard from the Split
Point for the Voices (RIGHT 1, 2, and 3).
• Lower: A keyboard part played on the left side of the keyboard from the Split
Point for the Voices. This is not affected by the on/off status of the [ACMP]
button.
2
Touch [>] to call up the other page, and then select which MIDI messages are to be
transmitted for each Part.
The following MIDI messages can be set on the Transmit/Receive display.
• Note (Note events) .......................................
• CC (Control Change) ...................................
• PC (Program Change) ..................................
• PB (Pitch Bend) ...........................................
• AT (After Touch)..........................................
Alternates between the two pages.
1
The dots corresponding to each channel (1–16) flash briefly whenever
any data is transmitted on the channel(s).
page 82
page 82
page 82
page 82
page 82
page 115. This determines which
2
NOTE
If the same transmit channel is assigned
to several different parts, the transmitted
MIDI messages are merged to a single
channel—resulting in unexpected
sounds and possible glitches in the
connected MIDI device.
NOTE
Preset Songs cannot be transmitted
even if the proper Song channels 1–16
are set to be transmitted.
PSR-A5000 Reference Manual
11
117