Philco POB 321 User Manual page 18

WARNING:
Before installing the skewer, check that the oven is turned off !
Remove the clamps from the skewer by loosening the respective screws and pull the skewer through the
chicken. Then reattach the clamps and secure the chicken by tightening the clamp screws.
Place the baking tray on to the second rail and place the skewer holder into the hole in the baking tray – see
picture. A handle or rack is supplied depending on the model.
Move the skewer insertion hole cover to the side, then insert the skewer tip into the hole located in the rear part
of the oven and place the other end into the holder. Check that the skewer is properly secured on both sides.
If the handle is attached, remove it fi rst. The handle is only used for inserting and removing the skewer in and
out of the oven. Close the door.
Anti-slip rack
Removing the rack
NOTE:
The accessories depend on the model.
EN - 16
Copyright © 2012, Fast ČR, a. s.
Skewer
handle
Skewer holder
Baking tray

Insert the anti-slip rack into the oven on any rail with the elevated
end fi rst.

The anti-slip rack is intended only for use in the oven.
Pull out the rack as
shown in the picture.
After releasing from the
grooves, lift upwards.
Unscrew G screws from
the enamel catalytic
panel.
Hole in the
rear part of
the oven
Small metal cover
Skewer
Removing the catalytic panel
04/2012