Liabilities; Manufacturer's Liability - REMEHA Quinta Pro series Installation, User And Service Manual

1 Safety

1.3 Liabilities

8
Caution
Make sure the boiler can be reached at all times.
The boiler must be installed in a frost-free area.
In the case of a fixed connection to the power cord,
you must always install a main bipolar switch with an
opening gap of at least 3 mm (EN 60335-1).
Drain the boiler and central heating system if you
are not going to use your home for a long time and
there is a chance of frost.
The frost protection does not work if the boiler is out
of operation.
The boiler protection only protects the boiler, not the
system.
Check the water pressure in the system regularly. If
the water pressure is lower than 0.8 bar, the system
must be topped up (recommended water pressure
between 1.5 and 2 bar).
Note
Keep this document near to the boiler.
Note
Casing panels may only be removed for maintenance
and servicing purposes. Refit all panels when mainte­
nance work and servicing are complete.
Note
Instruction and warning labels must never be removed
or covered and must be clearly legible throughout the
entire service life of the boiler. Replace damaged or il­
legible instruction and warning labels immediately.
Note
Modifications to the boiler require the written approval
of Remeha.

1.3.1 Manufacturer's liability

Our products are manufactured in compliance with the re­
quirements of the various Directives applicable. They are
therefore delivered with the
necessary. In the interests of the quality of our products, we
strive constantly to improve them. We therefore reserve the
right to modify the specifications given in this document.
Our liability as manufacturer may not be invoked in the fol­
lowing cases:
Failure to abide by the instructions on installing the appli­
ance.
Failure to abide by the instructions on using the appliance.
Faulty or insufficient maintenance of the appliance.
marking and any documents
123157 - v.06 - 24022015