Changing The Ha Configuration - HP StoreAll 8800 Administrator's Manual

7. Next, enable NIC monitoring on the VIF. Select the new user NIC and click NIC HA. The NIC
HA Config dialog box appears. See
information. After completing the NIC HA Config dialog box, the NIC HA Setup window
appears again. Continue configuring High Availability for any other NICs. When that is
completed, click Finish to exist the wizard.

Changing the HA configuration

To change the configuration of a NIC, select the server on the Servers panel, and then select NICs
from the lower Navigator. Click Modify on the NICs panel. The General tab on the Modify NIC
Properties dialog box allows you change the IP address and other NIC properties. The NIC HA
tab allows you to enable or disable HA monitoring and failover on the NIC and to change or
remove the standby NIC. You can also enable link state monitoring if it is supported on your cluster.
See "Configuring link state monitoring for iSCSI network interfaces" in the Administrator Guide
for your platform.
"Configuring HA on a NIC" (page 45)
Configuring High Availability on the cluster
for more
43