HP StoreAll 8800 Administrator's Manual page 26

2. Under Home, select Discovery.
3. Select the Sources tab and then select New.
4. You can discover devices by entering a single IP address or a range of IP addresses, or listing
several IP addresses. Enter the IP address (or addresses) into the table of IP addresses.
5. Select Start Discovery to begin device discovery.
While the device discovery is in process, you will see Discovery Status: Running.
Once device discovery is completed, you will see Discovery Status: Stopped. You
will also see:
Number of discovery operations to be run during this cycle: <##>
Number of discovery operations completed during this cycle: <##>
6. When device discovery completes, select Devices under Home to view the devices. You will
see a menu of device groups with selections for All Devices, Computer, Other, and Storage.
This screen shows the All Devices selection.
If the device was discovered properly, a green check mark displays in the Monitoring &
Collections column.
7. For entitlement purposes, you must enter, for each device, the values for the Customer Entered
Serial Number and Customer Entered Product Number that you entered on the Entitlements
dialog box in the StoreAll OS software (these fields are called Override Serial Number and
Override Product Number in HP IRS). If the discovered device displays a green check mark
in the Warranty & Contract column, then the device is enabled for HP Support.
NOTE:
You must also enter X9000 for the Customer Delivery ID for all StoreAll devices and MSA
arrays.
To enter details, select the device name and then select Hardware. The following screen
appears.
26 Getting started
This is not required for ProLiant blade servers.