Customization Basics; Refrigerator Location; Optional Accessory Kits - Monogram 36” Installation Instructions Manual

Design Guide - Standard Installation

CUSTOMIZATION BASICS:

Framed Or Overlay Panels, Custom
Handles and Accessory Kits
These refrigerators are designed to be customized with
decorative panels. Field installed custom door and grille
panels are required.
Side Panels
Side panels must be used whenever the sides of the
refrigerator will be exposed.

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.

OPTIONAL ACCESSORY KITS

• ZKBSN720SS: Unification kit for an integrated
appearance on 2 stainless steel models installed
side-by-side.
• ZKBFN720NII: Unification kit for an intergraded
appearance on 2 custom panel models installed side-
by-side.
• ZKLN: Visor handle kit for use on custom panel
models in a standard installation.
Kit includes two handles.
• ZKFN: Flush inset installation kit required for all flush
installations. Includes modified toe kicks, case trim,
and other required components.
8
31-1000452 Rev. 1