BodyCraft 302 Instruction Manual page 9

STEP 4
Assemble Cables and Pulleys simultaneously
Insert the threaded end of the Top Cable (28) into the bottom of the slot in the front of the Top
Frame (3) as shown in T1, and route over top of the two pulleys mounted in the Top Frame (3), then
down and over the left side (as if sitting on seat) pulley in the Press Arm Selector (11), under the
pulley mounted in the Front Upright (2), as shown in T4, over the right side pulley in the Press Arm
Selector (11), then under the pulley mounted in the Front Upright (2) as shown in T6, up and over
the pulley mounted on the Top Frame (3).
as shown in T7, down and around the top pulley in the Adj. Pulley Block (19) as shown in T8, up
and over left side pulley above the weigh stack on Top Frame (3), then down to the weight stack.
Screw the cable end into the Selector Rod (as shown in T10).
T10
3
T9
T4
T7
T8
2
T10
Top Cable Assembly
TOP CABLE (28)
ball with hook end
T2
T1
11
T3
T5
T6
T6
59
59
80
68
2
T7
3
83
52
T8
70
19
T9
3
59
80
83
8
bolt end
T1
68
80
59
83
80
3
T2
52
3
59
80
83
70
T3,T4,T5
69
T3
70
T4
52 83
STEP 1
T3
83
68
80
59
T4
STEP 2
T4
59
80
83
52
68
80
59
52
11
T5
83
11
11
T5