Installing Cover; Installing Crankshaft Pulley And Damper - Mitsubishi S6S-Y3T61HF Service Manual

REASSEMBLY OF BASIC ENGINE

2.14 Installing cover

Tighten the cover mounting bolts evenly.

2.15 Installing crankshaft pulley and damper

The bar could come off. Be very careful.
(1) Screw two guide bolts into the threaded holes at the rear
end of the crankshaft. Place a bar across the two guide
bolts so that the crankshaft does not turn.
(2) Install the crankshaft pulley and tighten the nuts to the
specified torque.
(3) Install the damper to the crankshaft pulley.
7-14
CAUTION
S6S-Y3T62HF
Cover
Installing cover
S6S-Y3T61HF
Bearing case
Cover
Installing cover
Crankshaft pulley
490 ± 10 N･m
{50 ± 1 kgf･m}
[362 ± 7.2 lbf･ft]
(Front)
Installing crankshaft pulley
Installing damper
Prevent crankshaft
from rotating
Guide bolt
(M12×1.25mm)
(Rear)