Basic Safety Precautions Fire And Explosions; Keep Flames Away; Always Swich The Water Heater On (Emergency Generator With Water Heater); Keep Engine Surrounding Area Tidy And Clean - Mitsubishi S6B3 Operation & Maintenance Manual

Table of Contents

Advertisement

Chapter 1 BASIC SAFETY PRECAUTIONS
Fire and Explosions

Keep Flames Away

Do not use flames near the engine (in
the engine room). Fuel gas vapor or
other gas can catch fire and produce
dangerous situations.
Wipe off spilled fuel, oil and LLC
immediately and thoroughly. Spilled fuel, oil and LLC
may ignite and cause a fire.
Store fuel and engine oil in a well-ventilated area.
Make sure that the caps of fuel and engine oil contain-
ers are tightly closed.
Always Swich the Water Heater
ON
(Emergency generator with
water heater)
Always swich the water heater ON (automatic mode)
through a whole year.
If the switch is not ON (automatic mode), each cylin-
der varies considerably in combustion at the starting
up the engine. Unburned fuel may explode in the
exhaust pipe.
Keep Engine Surrounding Area
Tidy and Clean
Do not leave combustible or explosive materials, such
as fuel, engine oil and LLC, near the engine. Such
substances can cause fire or explosion.
Remove dust, dirt and other foreign materials accu-
mulated on the engine and surrounding parts thor-
oughly. Such materials can cause fire or the engine to
overheat. In particular, clean the top surface of the
battery thoroughly. Dust can cause a short-circuit.

Ventilation of Engine Room

Always provide adequate ventilation in the engine
room. Insufficient air in the room can cause an
increase in the engine temperature and a decrease in
the output power and performance. It is highly recom-
mended to calculate the required amount of air supply
to the engine and install an adequate ventilation sys-
tem before installing the engine.
Do Not Open Side Cover Until
Engine Cools
Do not attempt to open the side cover of the crank-
case before the engine cools down. Wait at least 10
minutes after stopping the engine.
Opening the cover when the engine is hot allows fresh
air to flow into the crankcase, which can cause oil mist
to ignite and explode.
Care for Fuel, Oil and Exhaust
Gas Leakage
If any fuel, oil or exhaust gas leaks are found, immedi-
ately stop the engine and take corrective measures to
stop leakage.
Such leakages, if left uncorrected, can cause fuel or
engine oil to reach hot engine surfaces or hot exhaust
gas to contact flammable materials, possibly leading
to personal injury and/or damage to equipment.
Use Explosion-proof Lighting
Apparatus
When inspecting fuel, engine oil, coolant, battery elec-
trolyte, etc., use a flameproof light. An ordinary light-
ing apparatus may ignite gas and cause it to explode.
Prevent Electrical Wires From
Short-circuiting
Avoid inspecting or servicing the electrical system with
the ground cable connected to the battery. Otherwise,
a fire could result from short-circuiting. Be sure to dis-
connect the battery cable from the negative (-) termi-
nal before beginning with the work procedure.
Short-circuits, possibly resulting in fire, may be
caused by a loose terminal or damaged cable/wire.
Inspect the terminals, cables and wires, and repair or
replace the faulty parts before beginning with the ser-
vice procedure.
Keep Fire Extinguishers and a
First-aid Kit Handy
Keep fire extinguishers handy, and
become familiar with their usage.
Keep a first-aid kit at the designated
place where it is easily accessible by
anyone at any time.
Establish response procedures to follow in the event
of fire or accident. Provide an emergency evacuation
route and contact points and means of communication
in case of emergency.
1-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents