Removing Front Bearing; Removing Stator; Removing Regulator Assembly; Removing Rectifier Assembly - Mitsubishi S6S-Y3T61HF Service Manual

2.5.5

Removing front bearing

Remove the screw, and then remove the bearing retainer and
front bearing from the front bracket.
2.5.6

Removing stator

CAUTION
Unsoldering must be finished as quickly as possible.
Extended heating will damage the diodes.
Unsolder the joint of the stator and remove the stator from
the rectifier.
2.5.7

Removing regulator assembly

Remove the screws of the regulator assembly and then
remove the regulator assembly.
2.5.8

Removing rectifier assembly

(1) Remove the screw and nut from the rectifier.
(2) Remove the rectifier assembly.
Front bracket
Removing front bearing
Lead wire
Rectifier
Removing stator
Rear bracket
Rectifier
Removing regulator assembly and rectifier assembly
ELECTRICAL SYSTEM
Front bearing
Stator
Regulator assembly
12-19