ELECTRICAL SYSTEM
(3) Check continuity between segments in various
combinations.
If poor or no continuity is found, replace the armature
with a new one.
2.3.8
Inspecting field coil
(1) Check for no continuity between the end of the coil
(brush) and the yoke.
(2) Check continuity between both ends of the coil.
(3) Check that the pole piece and the coil is not loosen.
(4) If it is defective, replace the yoke with a new one.
2.3.9
Inspecting rear bracket
Replace the rear bracket if the bearing is worn.
2.3.10 Inspecting overrunning clutch operation
CAUTION
Do not clean the overrunning clutch in wash oil since
grease is applied inside.
Make sure that, when attempting to turn the overrunning
clutch, it locks in one direction and rotates smoothly in the
opposite direction.
2.3.11 Inspecting front bracket
The ball bearing should rotate smoothly without abnormal
noise. If defective, replace the whole front bracket.
2.3.12 Inspecting gears of starter
Check gears of the starter for wear or damage. If faulty,
replace the gears.
12-14
Inspecting continuity between segment
Inspecting field coil
Inspecting overrunning clutch