Mitsubishi S6S-Y3T61HF Service Manual page 199

(4) Put a mark B on the flange plate where aligned with the
mark A of the fuel injection pump.
CAUTION
When removing the flange plate from the fuel injection
pump assembly, be sure to put a mark on the flange
plate before removal to ensure proper reassembly.
(5) Unscrew the flange plate retaining bolt and remove the
fuel injection pump from the front plate.
(6) Remove retaining bolt, remove the flange plate from
the fuel injection pump.
CAUTION
When replacing parts, be sure to use OEM designated
parts.
If OEM parts are not used, the exhaust emission's war-
ranty be voided.
New parts may be updated due to improvement.
Fuel and exhaust system repairs should only be con-
ducted by an authorized Mitsubishi forklift truck dealer.
Tampering or adjusting the fuel system components
will void the warranty and could be in violation of the
EPA regulations.
The fuel injection pump is an emission control device.
Components inside the pump are specifically cali-
brated to meet the engine emissions requirements and
should never be disassembled or rebuilt.
If the pump fails to operate, replace the assembly with
an OEM replace part.
(7) Replace the fuel injection pump with a new one.
ADJUSTMENT AND OPERATION
B
Alignment mark of fuel injection pump
Flange plate
Front
plate
Removing fuel injection pump
A
Fuel injection
pump
Bracket
Bracket
13-5