Replacing Camshaft Bushing; Removing Camshaft Bushing; Installing Camshaft Bushing; Measuring Idler Bushing Inside Diameter And Idler Shaft Outside Diameter - Mitsubishi S6S-Y3T61HF Service Manual

3.7 Replacing camshaft bushing

3.7.1

Removing camshaft bushing

(1) Install a camshaft bushing installer set to the camshaft
bushing.
(2) Remove the camshaft bushing by tapping the end of the
rod of camshaft bushing installer set.
3.7.2

Installing camshaft bushing

(1) Install the camshaft bushing to a camshaft bushing
installer set.
(2) When driving in a bushing, tap the end of camshaft
bushing installer rod so that the oil hole in the bushing
aligns with the oil hole of the oil gallery.
3.8 Measuring idler bushing inside diameter
and idler shaft outside diameter
Measure the idler bushing inside diameter and idler shaft
outside diameter, and calculate the clearance between them.
If the measured value exceeds the limit, locate the defective
part and replace it.
Item
Clearance between
idler bushing and idler shaft
Standard Limit
0.009 to 0.050 mm 0.100 mm
[0.0004 to 0.0020 in.] [0.0039 in.]
INSPECTION AND REPAIR OF BASIC ENGINE
Bushing
Camshaft bushing
installer set
P/N:30691-00010
Removing camshaft bushing
Piece
Camshaft bushing
installer set
P/N:30691-00010
Installing camshaft bushing
Measuring idler bushing inside diameter and idler shaft
outside diameter
Adapter
Rod
Bushing
Adapter
Rod
Oil hole
Measuring
direction
Measuring
position
6-13