Preseason Preparation - Sea-doo GTS Operator's Manual

Gts series; gti series; gtr series; wake series
Hide thumbs Also See for GTS:
Table of Contents

Advertisement

STORAGE AND PRESEASON PREPARATION
Spray XPS LUBE (P/N 293 600 016)
over all metallic components in engine
compartment.
NOTE: The seat should be left partially
open during storage. This will prevent
engine compartment condensation
and possible corrosion.
Body and Hull
Body and Hull Cleaning
Wash the body with a soap and wa-
ter solution (use only mild detergent).
Rinse thoroughly with fresh water. Re-
move marine organisms from the hull.
NOTICE
Never clean fiberglass
and plastic parts with strong deter-
gent, de-greasing agent, paint thin-
ner, acetone, or other strong chemi-
cal or petroleum cleaners.
Body and Hull Repair
If any repairs are needed to body com-
ponents or to the hull, contact your au-
thorized Sea-Doo dealer.
Body and Hull Protection
Apply a good quality marine wax to the
body.
If the watercraft is to be stored outside,
cover it with an opaque tarpaulin to pre-
vent sun rays and grime from affecting
the plastic components, watercraft fin-
ish, as well as preventing dust accumu-
lation.
NOTICE
The
never be left in water for storage.
Never leave the watercraft stored in
direct sunlight. Never store water-
craft in a plastic bag.

Preseason Preparation

Maintenance preparation must be per-
formed in conjunction with
MAINTENANCE CHART
Ensure to perform all tasks included in
the 100 HOURS OR 1 YEAR column.
______________
122
watercraft
should
PERIODIC
.
Since technical skills and special
tools are required, some operations
should be performed by an authorized
Sea-Doo dealer.
NOTE: It is highly recommended that
an authorized Sea-Doo dealer perform
factory campaigns in addition to the
preseason preparation, all at the same
time.
WARNING
Only perform procedures as de-
tailed in the
TENANCE CHART
mended that the assistance of an
authorized Sea-Doo dealer be pe-
riodically obtained on other com-
ponents and systems not covered
in this guide.
NOTICE
When component condi-
tions seem less than satisfactory, re-
place using only genuine BRP parts,
or approved equivalents.
PERIODIC MAIN-
. It is recom-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents