Changing Numerical Display Indication - Sea-doo GTS Operator's Manual

When the LOW FUEL indications
come on in the multifunction gauge,
the "TIME TO EMPTY" and "DISTANCE
TO EMPTY" functions will indicate "0"
(zero) if they are the selected indica-
tion.
To display the watercraft fuel con-
sumption, carry out the following:
1. Press the MODE button repeatedly
until FUEL CONSUMPTION is visi-
ble in the multifunction display.
MESSAGE DISPLAYED
FUEL CONSUMPTION
2. Press the UP/DOWN button to tog-
gle to the desired fuel consumption
display mode.
1
FUEL CONSUMPTION DISPLAY
MODE
1. INSTANT FUEL CONSUMPTION
message
2. Applicable value
3. Press the SET button to save the
setting and return to the main dis-
play.
INFORMATION CENTER (GAUGES) (GTI/GTR/WAKE)
NOTE: The fuel consumption value
selected will be displayed in the nu-
merical display. Double click the SET
button to reset the average fuel con-
sumption indication. The display will
momentarily indicate zero (0).
VTS Mode
The VTS MODE function is used to
manually set the VTS or change VTS
PRESET settings.
Refer to
subsection for detailed instructions.
Display
The DISPLAY function is used to
change the indication in the numerical
display. Refer to
ICAL DISPLAY INDICATION
Fault Codes
The FAULT CODES function is used to
display active fault codes.
Refer to
section for details.
Key Mode
The KEY MODE function is used for
2
changing LEARNING key settings.
Refer to
tion for detailed instructions.
Settings
The SETTINGS function is used for:
– Changing the clock setting, refer to
MULTIFUNCTION GAUGE SETUP
– Activating the iBR override function,
refer to
Changing Numerical
Display Indication
To change the indication in the numeri-
cal display, carry out the following:
1. Press the MODE button on the RH
handlebar repeatedly until DISPLAY
is visible in the multifunction display.
_______________
OPERATING INSTRUCTIONS
CHANGING NUMER-
MONITORING SYSTEM
OPERATING MODES
SPECIAL PROCEDURES
.
sub-
subsec-
.
.
63