Spark Plugs - Sea-doo GTS Operator's Manual

Ignition Coil Installation
NOTE: Prior to inserting the ignition
coil on its spark plug, apply sealant as
IGNITION COIL LUBRI-
described in
CATION
.
1. Install coil in cylinder head hole.
2. Push the ignition coil down to se-
curely install it on the spark plug tip.
3. Ensure the seal seats properly with
top surface of engine valve cover.
smr2009-032-004_a
TYPICAL
1. Seal properly seated

Spark Plugs

Spark Plug Removal
1. Open seat.
2. Disconnect the ignition coil input
connector.
3. Remove ignition coil. Refer to
TION COIL REMOVAL
WARNING
Never remove an ignition coil from
a spark plug without disconnect-
ing it from the wiring harness.
Flammable vapors may be present
in the bilge. Should the tether cord
be installed on the engine cut-off
switch, a spark could be generated
at the coil spark plug end which
could cause an explosion.
4. Using a spark plug socket, release
the torque applied to the spark plug.
IGNI-
.
______________
MAINTENANCE PROCEDURES
1
A00E0BA
1. Approved socket
2. Improper socket
5. Clean the spark plug and cylinder
head with pressurized air.
6. Unscrew spark plug then use the
ignition coil to take spark plug out of
spark plug hole.
smr2009-032-003_a
1. Ignition coil
2. Spark plug
Spark Plug Installation
Prior to installation, ensure the contact
surfaces of the cylinder head and spark
plug are free of grime.
1. Using a wire feeler gauge, set elec-
trode gap as specified in the follow-
ing chart.
2
113