Ski/Wakeboard Post (Wake); Fuses - Sea-doo GTS Operator's Manual

MAINTENANCE PROCEDURES
Ski/Wakeboard Post
(Wake)
Ski/Wakeboard Post Inspection
Check ski/wakeboard post operation.
Ensure it slides up and down easily.
Check locking mechanism operation.
Check fasteners tightness. If some-
thing is found defective, don't use
ski/wakeboard post and see an autho-
rized Sea-Doo dealer for repair.
Ski/Wakeboard Post Lubrication
Clean ski/wakeboard post and apply
a light coat of SUPER LUBE GREASE
(P/N 293 550 030).
Lubricate post throughout its length.
Wipe off all excess grease and reinstall
post.
Extend and retract several times to dis-
tribute the lubricant.

Fuses

Fuse Removal and Installation
Use the fuse remover/installer in-
cluded in the fuse box to ease fuse
removal.
Fuse Inspection
If an electrical problem occurs, check
the fuses. If a fuse is burnt, replace by
one of the same rating.
______________
116
A15E0KZ
TYPICAL
1. Fuse
2. Check if melted
3. Ampere rating
WARNING
Do not use a higher rated fuse
as this can cause severe dam-
age. If a fuse has burnt out, the
source of the malfunction should
be determined and corrected be-
fore restarting. See an authorized
Sea-Doo dealer for servicing.
Fuse Location
All fuses are located inside a single
fuse box.
To access the fuse box, open the front
storage cover.
Remove the two plastic rivets and the
rubber tie securing the battery access
panel at the back of the storage com-
partment. The fuse box is located
ahead of the fuel tank just under the
gauge area, attached to the battery
holder.
1
2
3