Ride Plate And Water Intake Grate - Sea-doo GTS Operator's Manual

smo2009-002-139_a
TYPICAL
1. Hose adapter (optional, not mandatory)
2. Quick connect fitting (optional, not
mandatory)
3. Garden hose
To flush, start engine then immediately
open the water tap.
CAUTION Certain
nents in the engine compartment
may be very hot. Direct contact may
result in skin burn. Do not touch any
electrical parts or propulsion system
component when the engine is run-
ning.
NOTICE
Never flush a hot en-
gine. Always start the engine before
opening the water tap. Open wa-
ter tap immediately after engine is
started to prevent overheating.
Run the engine 90 seconds at idle
speed.
NOTICE
Never run engine without
supplying water to the exhaust sys-
tem when watercraft is out of water.
Ensure water flows out of jet pump
while flushing. Otherwise, refer to an
authorized Sea-Doo dealer for servic-
ing.
NOTICE
Never run engine longer
than 2 minutes. Drive line seal has
no cooling when watercraft is out of
water.
Close the water tap, run the engine at
5000 RPM for 5 seconds and stop the
engine.
NOTICE
tap before stopping the engine. If
not, water will get inside the engine.
NOTICE
adapter after flushing operation (if
used).
Ride Plate and Water Intake
Grate

Ride Plate and Water Intake Grate

Inspection
Inspect ride plate and jet pump wa-
ter intake grate for damage. See your
Sea-Doo dealer to have any damaged
part repaired or replaced.
compo-
The tether cord must always be
removed from the engine cut-off
switch prior to inspecting the in-
take grate.
F18J04Y
TYPICAL — INSPECT THESE AREAS
1. Water intake
2. Ride plate
______________
MAINTENANCE PROCEDURES
Always close the water
Remove quick connect
WARNING
1 2
115