Slow Speed Mode - Sea-doo GTS Operator's Manual

CRUISE MODE INDICATOR
Changing Set Cruise Speed
To increase or decrease the set cruise
speed:
1. Hold the throttle lever all the way in
to the handlebar.
2. On the RH handlebar,
UP/DOWN button.
sdd2009-001-024_h
CHANGING SET CRUISE SPEED
1. Throttle lever
2. UP button
3. DOWN button
While the UP/Down is being pressed
to change the speed setting, the fol-
lowing will appear in the multifunction
gauge.
1
FUNCTION SELECTED - CRUISE
MODE
1. CRUISE MODE _ SPEED
ADJUSTING
2. Cruise speed set point indication
NOTE: Pressing the UP/DOWN but-
press
ton repeatedly will change the cruise
set speed in single increments. Press-
ing and holding the button will increase
or decrease the speed until the button
is released.
Deactivating Cruise Mode
To deactivate cruise mode:
1. Release the throttle lever.
2. Press the cruise button.
Deactivation of cruise mode is indi-
cated by:
– The CRUISE indicator will turn off.
– A BEEP will be heard.
NOTE: If the throttle lever is not fully
released when the cruise button is
pressed to deactivate cruise mode,
the BEEP will not be heard and the
cruise indicator will remain on. The
speed limiting function of cruise mode
will stay active until the throttle is fully
released, then the BEEP will be heard
and the cruise indicator will go out.

Slow Speed Mode

The Intelligent Throttle Control also
allows for a Slow Speed Mode where
the driver can adjust and set idle speed.
This is useful when operating in slow
speed zones where the driver must be
especially attentive to possible obsta-
cle avoidance.
_______________
OPERATING MODES
2
93