What To Do After Launching The Watercraft - Sea-doo GTS Operator's Manual

Ensure the front cover, glove box, and
seat are closed and latched.
WARNING
Ensure the seat, glove box, and
front storage compartment cover
are securely latched.
Wakeboard Rack (WAKE Model
Only)
WARNING
Ensure wakeboard rack is properly
secured to watercraft body, and
that the wakeboard is properly po-
sitioned and secured to the rack
prior to using watercraft. Ensure
wakeboard retaining straps are in
good condition.
Ski/Wakeboard Post (WAKE Model
Only)
Make sure ski/wakeboard post is fully
extended and locked before use.
Completely retract and lock when not
used.
WARNING
Use caution
boarder in tow as tow rope may
backlash to watercraft when re-
leased. Never perform a sharp
turn when towing a skier, wake-
boarder or any toy.
NOTICE
The ski/wakeboard post is
designed for towing a skier or wake-
boarder with a maximum gross
weight of 114 kg (250 lb).
Engine Cut-Off Switch and Engine
START/STOP Button
Press the start button once without in-
stalling the tether cord cap on the en-
gine cut-off switch.
Install the tether cord cap on the en-
gine cut-off switch.
________
with skier/wake-
SAFETY INFORMATION
Press the START/STOP button to start
the engine, then stop it by pressing the
START/STOP button a second time.
NOTE: To allow engine starting, the
tether cord cap must be properly in-
stalled on the engine cut-off switch
within 5 seconds of pressing the
START/STOP button.
Restart the engine, then stop it by re-
moving the tether cord from the engine
cut-off switch.
WARNING
Should the tether cord cap be
loose or fail to remain on the en-
gine cut-off switch, replace the
tether cord immediately in order
to avoid unsafe use. If remov-
ing the tether cord cap from the
engine cut-off switch or pressing
the START/STOP button does not
stop the engine, do not use the
watercraft. See your authorized
Sea-Doo dealer.
What to Do After
Launching the Watercraft
Check the items listed in the follow-
ing table after launching the watercraft
and before going for a ride.
ITEM
Information
Center
Intelligent Brake
and Reverse
System (iBR)
Variable Trim
System (VTS)
(as applicable)
Information Center (Gauge)
1. Press START/STOP button and in-
stall the tether cord cap on the en-
gine cut-off switch.
________
PRE-RIDE INSPECTION
OPERATION
Check operation
Check operation
Check operation
✓
39