Engaging/Using Ski Mode - Sea-doo GTS Operator's Manual

OPERATING MODES
RAMP 1 provides:
– Slowest launch (smoothest)
– Slowest acceleration rate
– Slowest TARGET SPEED range.
RAMP 5 provides:
– Quickest launch
– Quickest acceleration rate
– Highest TARGET SPEED range.
TARGET SPEED Function
The TARGET SPEED function limits the
maximum towing speed.
Once the RAMP has been selected,
an average PWC target speed for that
RAMP will be visible in the numerical
display.
The average speed displayed and the
speed range available is dependent on
the RAMP selected. The higher the
RAMP number, the higher the speed
range.
The operator may increase or decrease
the target speed to any value within the
selected RAMP speed range.
NOTE: If the desired target speed can-
not be set in the selected RAMP, you
must exit then reengage SKI MODE,
and select a different RAMP.
Engaging and Using Ski Mode
To engage ski mode, carry out the fol-
lowing steps:
1. Release throttle lever.
NOTE: Ski mode cannot be engaged if
the throttle lever is not fully released,
and if CRUISE or SLOW SPEED mode
is engaged. A message will appear in
the multifunction display advising you
of the situation. Follow the instruc-
tions in the display.
2. Press the MODE button repeatedly
until SKI MODE is visible in the mul-
tifunction display.
______________
96
sdd2009-001-024_e
TYPICAL
1. MODE button
MESSAGE DISPLAYED
SKI MODE
3. Press SET to enter the function.
The multifunction gauge message
will change to RAMP. The RAMP
setting number will be visible in the
numerical display.
sdd2009-001-024_f
1. SET button