Table of Contents
Advertisement
5. Mix epoxy in mixing cup and use a tapered stick
to apply the epoxy inside the pre-drilled holes in
the leading edge of the rudder. Apply epoxy to
trailing edge of each hinge.
6. Carefully slide the rudder onto each hinge and
against the trailing edge of the fin. Wipe away
excess epoxy with alcohol wetted wipes.
7. Ensure there is no gap between fin and rudder.
Allow epoxy to fully cure.
Note: Use clear covering for sealing the hinge
gaps. This is an optional step but is
recommended
Rudder Horn, Pull-Pull Cable and
Servo Installation
1. Gather the rudder control linkage parts shown
below. 2 rudder cables, 4 ball link assemblies, 2
flat washers, 4 threaded couplers, 4 brass swag-
ing tubes, 2 left and 2 right side control horns,
and 12 2.6 x 12mm wood screws.
19
Hide quick links:
Advertisement
Table of Contents
