Rudder And Pull-Pull Cable Assembly - AeroWorks 35cc EXTRA 300 ARF-QB Assembly Manual

RUDDER AND PULL – PULL CABLE ASSEMBLY
Rudder Installation
1. Gather the rudder, five hinges, rubbing alcohol,
petroleum jelly and epoxy materials as shown.
Use 15-30 minute epoxy to ensure adequate
working and cleanup time.
2. Prep all hinges for installation by applying Vase-
line petroleum jelly or light oil to the hinge joint.
This ensures no epoxy gets into the hinge during
assembly.
3. Mix epoxy in mixing cup and use a tapered stick
to apply the epoxy inside the pre-drilled holes in
the trailing edge of the fin. Apply epoxy to one
side of each hinge and insert the hinge com-
pletely into the hole. Ensure the hinge axis is
vertical and parallel to the trailing edge of the fin
before epoxy cures. Wipe away excess epoxy
with alcohol wetted wipes.
4. Epoxy the hinges into the fin first and allow ep-
oxy to fully cure.
18