Change Spool - XYZ Printing da Vinci Jr.1.0 User Manual

CHANGE SPOOL

1 First retrieve fi lament spool to install the fi lament
spool axle ring.
Install the sensor chip. Please pay special attention to
3
the position of the installation holes on the chip.
Place the assembled fi lament spool (with the spool axle
5
rings) on the fi lament holder on the left side of the printer.
7 Open the release arm and push the fi lament all the way
to the bottom so that the front end of the fi lament is
completely inserted into the feed module.
Load Filament
2
Take out and separate the fi lament spool
axle ring into its two components.
Insert the fi lament spool axle ring components
4
to either side of the fi lament spool, and use a
cruciform screwdriver to tighten and secure the
rings to the axle to complete the installation of
the fi lament spool axle rings.
Pull out a section of the fi lament and insert it into the
6
feed port.
Caution: Pay attention to the direction the
fi lament is being pulled out and ensure that the
fi lament spool axle is being rotated in the correct
manner.
da Vinci Jr.1.0
2015
Ver. 1.6 June
P 6