Preparation Of Tools; Quick Cleaning; Standard Cleaning - XYZ Printing da Vinci Jr.1.0 User Manual

Note:
The machine can be turned off only when the cooling fan of the print head stops running after the print is
completed. Turning off the power directly may clog the print head.
This section describes how to clean the feed module. After heavy use of printer, if feeding of material becomes diffi cult or
impossible, please follow these steps.

Preparation of Tools

A. Cleaning brush that comes with the printer
A. Quick Cleaning
1 Use the "UNLOAD FILAMENT" function to loosen and
remove the fi lament.
B. Standard Cleaning
1 Use the screwdriver to remove the screw and open the
top cover.
3 Use the cleaning brush to scrub the gear; after removing residues of
fi lament on the gear, you can insert the guide tube and put the cover
back and then enjoy printing again.
Please peruse the product instruction manual before using this product.
B. Screwdriver (T10) for standard cleaning procedure
Important Notice
References:
Please refer to CLEAN NOZZLE
to remove the blocks out of the
print head.
2 Use the cleaning brush to scrub the feed gear back
and forth to remove the chips of fi lament out of the
gear. Replace the wire after the cleaning is completed.
2
Press the black rubber fi xer on top of hole and pull
the guide tube out.
da Vinci Jr.1.0
2015
Ver. 1.6 June
P 17 P 17