Change Nozzle; Clean Nozzle - XYZ Printing da Vinci Jr.1.0A User Manual

CHANGE NOZZLE

Carry out the CHANGE NOZZLE function before changing modules. Once the printing module has moved to the operating
position, you can turn off the power
CHANGE NOZZLE
MODULE NOW ?
NO
YES

CLEAN NOZZLE

Tools Preparation
●
A. Feeding Path Cleaning Pin
Guide to Clean Nozzle
●
1
Select "UTILITIES" > "CLEAN NOZZLE" > "YES".
START CLEANING
NOZZLE NOW?
NO
YES
3 Insert the cleaner wire into the hole of the nozzle carefully with a nipper.
After inserting the wire, press "OK" to exit.
Note: If the materials still cannot extrude normally after performing the CLEAN NOZZLE function,
please follow the steps below to clean the feeding path again.
1
"UNLOAD" function again and wait until the extruder is heat up to 150
avoid potential burn injuries.)
2 Press the spring around the
feeding path and pull out the guide
tube. (Do not detach the black bus
above the nozzle.)
Please place the extruder to original position (HOME AXIS) and calibrate the print bed (CALIBRATE). Then, do print bed leveling
5
after completing clean nozzle. (Please refer to the "Print Bed Leveling" section).
and change the module.
REPOSITION NOW
PLEASE WAIT
Carbon deposits and dirt accumulated in the nozzle will increase
with the printing times and impact the printing quality. We suggest
that you clean the nozzle after every 25 hours of printing.
B. Cleaner Wire
3 Insert the feeding path cleaning pin into
the feeding path as far as it can go, and
stick it back and forth to remove the
carbon deposits and dirt completely.
UTILITIES
YOU CAN TURN OFF
POWER & CHANGE
NOZZLE NOW
2
Wait for the printer to warm up to the operating temperature.
You can start cleaning when "TIME TO CLEAN YOUR
NOZZLE" is displayed.
TIME TO CLEAN
YOUR NOZZLE?
[ OK ] WHEN FINISH
◦
C. (Care should be taken during the operation to
After cleaning, insert the guide tube onto the
4
nozzle.
da Vinci Jr.1.0A
Apr. 2017
P 12