Fuji Xerox DocuColor 5065II User Manual page 66

4 Copy
Ratio (3rd to 5th Buttons)
Select from preset ratios.
You can change the indicated ratios. For information about the setting procedures, refer to "Reduce/
Enlarge - Button 3-5" (P.225).
[More...]
Display the [Reduce/Enlarge] screen.
Refer to "When [Proportional %] is Selected" (P.64) or "When [Independent X-Y%] is Selected" (P.65).
When [Proportional %] is Selected
You can select a ratio from preset standard copy ratios. You can also enter a ratio
directly.
1
Select a copy ratio, or specify a
value.
4
100%
Copies are made at the same size as the original document.
Auto%
The copy ratio is automatically set based upon the document and paper sizes specified
in [Paper Supply], and the document is copied to fit in the specified size.
Note
Presets %
Select from preset ratios.
You can change the indicated ratios. For more information, refer to "Reduce/Enlarge Presets" (P.238).
Copy All (Full Screen)
The document is copied at a slightly reduced size to prevent image loss at the edge of
the original. If this option is selected, a check mark is added.
Important • If you select [Copy All], when you do not want to erase the edges of the document, set the
Entering the Ratio
Touch the window displaying a value, and then use the numeric keypad or the [ ] and
[ ] buttons to specify a ratio within the range of 25 to 400% in 1% increments.
64
• If you select [Auto%], specify a value other than [Auto] for [Paper Supply].
amount of edge erase to 0 mm. Note that if the amount is set to 0 mm, the edges of the
copied document may get dirty or the image loss may occur.