Close The System Unit - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

Keep removing memory modules two at a time until you
5.
have removed all that you intend to. Always remove
memory modules from the highest-numbered memory slots
first.

Close the system unit

If you are replacing the existing memory modules with
1.
new ones, turn to the section ''To Install Memory Modules'',
on page 5-2.
Insert the tabs on the front drive panel into the cutouts on
2.
the system unit and tilt the panel halfway down into the
system unit.
If there is no drive in the drive bracket, thread the cables
through the large cutout and tuck the ends of the cables
into the bracket, as shown in Figure 5-8, on page 5-12.
Carefully lower the end of the drive bracket onto the two
3.
posts that support it.
Internal Hardware Options 5–17