Printenv; Restart - DEC DECstation 5000 Model 100 Series Hardware Operator's Manual

At this prompt, you can only boot your worksystem software or
enter your console password.
Boot your worksystem software. Type boot and press
Return. This is the only boot command that you can use.
It has no options or arguments. It uses the values that you
set in the boot environment variable (see ''Environment
Variables'', on page 11-22). If you have not set the boot
variable, the command does not work.
Enter your console password. Type passwd and press
Return. Then type your console password at the
prompt. For the sake of security, the screen does not
display what you type.
After you enter your console password, the prompt changes
to the standard console prompt
console commands that are described in this chapter.
To stop using your console password, type passwd -c at the
standard console prompt and press Return. You will then have
unrestricted access to the console commands.

printenv

>>printenv [ env ]
The printenv command displays the values of environment
variables. If you specify the name of an environment variable,
the command displays the value of only that variable. See
''Environment Variables'', on page 11-22 for more information.

restart

>>restart
The restart command attempts to restart the worksystem
software. This command relies on a restart facility in the
worksystem software that you have to enable.
, and you can use all the
(>>)
Using the Console Commands 11–19
pwd: