DEC DECstation 5000 Model 100 Series Hardware Operator's Manual page 169

Table 10-3 (Cont.). Self-Test Error Messages for the Base System Slot
ni/cllsn The Ethernet controller in the base system slot is faulty. Copy the
ni/common entire message and call your system manager or Customer Support
ni/crc Center.
ni/ctrs
ni/dma1
ni/dma2
ni/int
ni/int-lb
ni/m-cst
ni/promisc
ni/regs
ni/setup
ni/esar The Ethernet address chip is faulty. Copy the entire message and call
your system manager or Customer Support Center.
ni/ext-lb The built-in Ethernet connector in the base system slot or the loopback
connector attached to the Ethernet connector is faulty. Replace the
loopback connector, if there is one, or make sure that the network
cable is connected properly, see Chapter 3, ''To Install ThickWire
Ethernet Loopback Connectors'', on page 3-2. If this message appears
again, copy the entire message, and call your system manager or
Customer Support Center.
rtc/nvr Interrupt handling or timekeeping in the system module is faulty.
rtc/period Copy the entire message and call your system manager or Customer
rtc/regs Support Center.
rtc/time
scc/access The controller for a communications connector is faulty. Copy the
scc/dma entire message and call your system manager or Customer Support
Center.
scc/int The controller for a communications device fails to interrupt the
communications signals when appropriate. Copy the entire message
and call your system manager or Customer Support Center.
10–18 Troubleshooting
(continued on next page)