Clearances - Yunca Gas jervois Operation, Maintenance And Warranty Manual

CLEARANCES

The YUNCA JERVOIS FLUED GAS HEATER should be installed with clearances equal to or
greater than those recommended below and comply with NZS 5261/ AG601.
This is to ensure adequate air circulation around the heater and avoid heat damage to wall coverings.
Note: If walled surface is non-combustible i.e. brick or steel, side clearances may be reduced to
100mm. Corner positions and back clearance remain the same.
(See Fig. 3 Below)
(Fig. 3)
19-07-05 Page 6 of 20 Operation Instructions for Jervois Freestanding Gas Heater March 2002