Divus TOUCHZONE TZ07 User Manual page 19

DIVUS TZ supports as well the use of a static IP address as also the usage of DHCP. Depending on your
network, these parameters must be configured correctly in order to connect DIVUS TZ with your network and
also with the internet (check out the screenshot in the middle, which shows the configuration menu for the
LAN port). If you are unsure about the correct configuration, please refer to your network administrator.
Note: When the connection has been established correctly, in the upper right corner of this configuration
page a blue symbol showing 2 PCs will be shown. Only when this symbol is active, the DIVUS TZ is correctly
connected to your network. If the symbol is white, no connection could be established.
DIVUS TZ furthermore supports also Wi-Fi-based connections. In order to enable this support, you will have
to acquire the DIVUS Wi-Fi stick (not included in the delivery) and connect it to the device. Afterwards you
can access the QuickSettings menu (can be accessed within the DIVUS LAUNCHER settings by swiping
downwards, starting from the upper right corner of the status bar) and select the option "Wi-Fi". The following
menu permits to enable the Wi-Fi function, scan for available networks and configure the connection:
Note: at successful connection, in the upper right corner oft he status bar the typical blue Wi-Fi symbol will
be shown. Only if this icon is shown and blue, the device will be able to communicate through Wi-Fi. DIVUS
TZ now also supports parallel Wi-Fi and LAN connections and offers the default Android settings for the
configuration.
The next 2 settings refer to the control of the RGB-LED of DIVUS TZ. The first option permits to use the blue
LED as orientation LED. When the checkbox is enabled, the LED will be continuously on and can be seen as
operating LED or as orientation LED by night.
The second option instead handles the control of the red LED and uses it to signal the current network
state. If DIVUS TZ is not connected to a network and the checkbox of this option is enabled, the red LED will
be turned on. As soon as the device connects to the network, the LED will turn off. Therefore, the option
„Network-Check LED" acts in the same way as the symbol of the network connection described in the note
above. Naturally, by disabling the corresponding checkbox, also this functionality can be disabled.
Note: The new TOUCHZONE series provides no more opening for the LEDs within the design frame.
Nevertheless, the LEDs will be kept enabled per default, in order to provide visual feedback during the first
operation / installation of the device.
The next setting is named „Show Navigation Bar" and permits to enable / disable the navigation bar visible at
the bottom of the screen. At delivery, the navigation bar is always active, since the contained soft keys could
be necessary when configuring and installing DIVUS TZ. A deactivation of the navigation bar can be useful if a
kiosk operation or a "real" full-screen visualisation of apps is required.