Drive Belt - Can-Am SPYDER F3TM 2016 Operator's Manual

Tire Tread Wear
Check minimum tread depth by using
the tread-wear indicators (hard rubber
bars molded at the base of the tread;
1 in figure below). Check in three loca-
tions across the tire tread:
– Outer edge
– Center
– Inside edge.
The tread-wear indicators will appear
across the treads that have been worn
down to the minimum tread depth.
When at least one tread-wear indicator
appears across the tread, have the tire
replaced as soon as possible by an au-
thorized Can-Am roadster dealer.
rmo2008-001-041_a
TIRE TREAD WEAR
1. Tread-wear limit indicator
A. Appropriate tread depth
B. Minimum tread depth, replace tire
It is normal to see uneven wear on tires
depending on how the vehicle is driven
and road conditions. The front tires
external or internal edges and the rear
tire center tread will wear unevenly
depending on if the vehicle is driven
smoothly or aggressively.
WARNING
The tires are designed to rotate
only in one direction. Do not
switch the left and right front
wheels. If a tire is mounted on the
incorrect side, you will have less
traction and could lose control.
Do not hold the front wheel spoke
while attempting to spin the front
wheel as your fingers may be
caught between the wheel and the
brake caliper.
Tire Rotation (Front)
Rotate front tires when tread depth
reaches 4 mm (5/32 in). This will maxi-
mize tire life.
The tires are designed to rotate
only in one direction. Do not
switch the left and right front
wheels. The tires must be dis-
mounted from the wheels for tire
rotation. If a tire is mounted on the
incorrect side, you will have less
traction and could lose control.
CAUTION Do not hold the front
wheel spoke while attempting to
spin the front wheel as your fingers
may be caught between the wheel
and the brake caliper.
Tire Registration Form
In the event of a tire recall, we can only
contact you if we have your name and
address. As a vehicle manufacturer,
BRP keeps a record of the Tire Iden-
tification Number (T.I.N.) associated
with the Vehicle Identification Number
(V.I.N.) (see
TION
) and its current owner informa-
tion.
If you replace any tire on your vehi-
cle, a "Tire Registration Form" must be
completed and sent to the tire manu-
facturer consumer service group. The
"Tire Registration Form" is available at
an authorized Can-Am roadster dealer.

Drive Belt

Visually inspect belt alignment and
condition before each ride.
_______________
MAINTENANCE PROCEDURES
WARNING
WARNING
VEHICLE IDENTIFICA-
95