Control Wiring - BFT ECOSOL Installation Manual

Libra ul-r pre-wired enclosure

Hide thumbs Also See for ECOSOL:

Table of Contents

START / CLOSE INPUT

The Start/Close input can be used for a single push button operation to open, stop and close commands

STOP / RESET BUTTON

The Stop button also resets the controller if two consecutive physical obstructions are detected.

This is a NORMALLY CLOSED contact. The factory installed jumper must be removed for stop

button to operate.

NOTE: If more than one device needs to be wired to the STOP input, they must be wired in series

3-BUTTON STATION (open, stop, close)

A 3-button station can be hard-wired using the START/CLOSE as close input. This input must be defined

as CLOSE ONLY INPUT at the controller. See page 25 (START-CLOSE) for directions.

CONTROL WIRING

www.BFTGateOpeners.com | (800) 878-7829

REMOVE FACTORY

INSTALLED JUMPER

Table of Contents

Show Quick Links

Table of Contents