Advertisement
E5 BT A
Please note this is a quick set up guide only and we highly recommend reading the full instruction manual.
*** Never run these motors upside down ***
The new E5 BTA 12 /18 motors are a 24V DC
NON-LOCKING
swinging gate operator. The motors are powered by a
separately mounted Thalia controller and both motors require 5 wires (2 x 1.5mm for the motors and 3 standard
security cables for the limits). The E5 BT A12 is designed for pedestrian gates up to 1.2m and 80kgs (with the unique
"Push & Go" feature) whereas the E5 BT A18 is designed for vehicle gates up to 1.8m and 100kgs.
MOUNTING GEOMETRY OPTIONS
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BFT E5 BT A
Summary of Contents for BFT E5 BT A
- Page 1 E5 BT A Please note this is a quick set up guide only and we highly recommend reading the full instruction manual. *** Never run these motors upside down *** The new E5 BTA 12 /18 motors are a 24V DC NON-LOCKING swinging gate operator.
- Page 2 MOUNTING THE ARTICULATION LEVER ARM MOUNTING THE BT A18 SLIDE LEVER...
- Page 3 MOUNTING THE BT A12 SLIDE LEVER CONNECTING THE MOTORS TO THE CONTROLLER These motors are a 5-wire system, 2 cables are for the motor drive (positive and negative) and should be a minimum of 1mm to 1.5mm square, and 3 wires are for the limits (encoder). You can either run two cables, a 2 core 1.5mm sq.
- Page 4 PROGRAMMING THE MOTORS ON THE CONTROL BOARD Once the motors are wired up, set both gates into the closed position and proceed through the simplified menu of the control board. Procedure: 1) Press the OK button once and the display will read “LANGUAGE” and then “ITA” (for Italian). By using the middle button, you can scroll down to “ENG”...
Need help?
Do you have a question about the E5 BT A and is the answer not in the manual?
Questions and answers